Rotating equipment & heat · No. 05
Vibration & temperature monitor
CGUV-STRUC-AVAN-001
Three-axis vibration and surface temperature with on-board condition analytics, mounted by magnet or stud on the bearing housing. Trending vibration and temperature shows bearing wear before it causes a failure.
- 3-axis · ±16 g
- Velocity RMS · kurtosis · crest
- IP66
- 2-yr battery
Specifications
At a glance.
| Measures | Velocity RMS, acceleration peak, kurtosis, crest factor; surface temperature |
|---|---|
| Range | ±16 g; 10–1000 Hz band; −20 to 80 °C operating |
| Mount | Magnet base or M6 stud on the bearing housing |
| Rating | IP66 |
| Power | Battery, about 2 years at 15-minute reporting |
| SKU | CGUV-STRUC-AVAN-001 |
Confirm site suitability, calibration and current product specifications before ordering. The product data sheet governs.
Request the data sheet →Where it fits
Typical places for the vibration & temperature monitor.
Food & beverage
Evisceration drives, chiller augers, fillers, extruders, dryer fans
General manufacturing
Spindles, presses, refiners, vacuum pumps, cranes, compressors
Automotive
Conveyor and skillet drives, presses, molders, oven fans
Warehousing & distribution
Sorter and conveyor drives, evaporator and condenser fans
Recommended for
- Aerospace
- Automotive Manufacturing
- Construction
- Data Centers
- Defense Manufacturing
- Education
- Food & Beverage Manufacturing
- General Manufacturing
- Government
- Heavy Equipment & Transportation
- Healthcare
- Life Sciences
- Marine
- Power Generation
- Recreational Vehicle Manufacturing
- Commercial Real Estate & Offices
- Hospitality
More in rotating equipment & heat
All rotating equipment & heat →
Explosion-proof vibration monitor
CGUV-STRUC-AVAN-002The same three-axis vibration and temperature sensor, certified for hazardous locations. Use it in classified areas such as flour, feed, carbon-black and solvent handling, and use No. 5 elsewhere.ATEX / IECExZone 0 / 1 / 2±16 gSpecs and usesRotating equipment & heat
Infrared surface-temperature sensor
CGUV-TEMP-DECL-001Non-contact infrared measurement of surfaces up to 1030 °C, including bearing housings, oven and kiln shells, dryer drums, compressor heads, and the lugs and breakers in a motor control center.−40 to 1030 °CNon-contactIP67Specs and usesRotating equipment & heat
3-phase current meter, 500 A
CGUV-ENGY-MILE-003Three split-core clamps on one self-powered node report current, amp-hours and phase balance on a motor feeder, showing single-phasing, overload heating and motors left running when the line is idle.3 × 500 A clamps±1%Self-poweredSpecs and usesPut the vibration & temperature monitor to work.
The planner builds a gateway and sensor schedule around the problem you want to see. A Cognituv engineer confirms placement and coverage, then sends a quote.