Rotating equipment & heat · No. 09
High-temperature probe, 500 °C
CGUV-TEMP-MILE-004
PT100 RTD probe on a sealed wireless transmitter for ovens, dryers, steam lines, heat-treat furnaces and exhaust ducts.
- −50 to 500 °C
- ±0.5 °C to 170 °C
- IP67
- 10-yr battery
Specifications
At a glance.
| Measures | Temperature, PT100 RTD |
|---|---|
| Range | −50 to 500 °C; ±0.5 °C to 170 °C, ±1 °C above |
| Mount | Probe in the exhaust or on the line; transmitter on a wall or pole |
| Rating | IP67 |
| Power | Battery, about 10 years |
| SKU | CGUV-TEMP-MILE-004 |
Confirm site suitability, calibration and current product specifications before ordering. The product data sheet governs.
Request the data sheet →Where it fits
Typical places for the high-temperature probe, 500 °C.
Food & beverage
Oven and dryer exhaust, steam lines
General manufacturing
Heat-treat furnaces, quench tanks, cure- press steam lines, dryer hoods
Automotive
E-coat and topcoat oven exhaust, heat- treat, die-cast
Recommended for
More in rotating equipment & heat
All rotating equipment & heat →Rotating equipment & heat
Vibration & temperature monitor
CGUV-STRUC-AVAN-001Three-axis vibration and surface temperature with on-board condition analytics, mounted by magnet or stud on the bearing housing. Trending vibration and temperature shows bearing wear before it causes a failure.3-axis · ±16 gVelocity RMS · kurtosis · crestIP66Specs and usesRotating equipment & heat
Explosion-proof vibration monitor
CGUV-STRUC-AVAN-002The same three-axis vibration and temperature sensor, certified for hazardous locations. Use it in classified areas such as flour, feed, carbon-black and solvent handling, and use No. 5 elsewhere.ATEX / IECExZone 0 / 1 / 2±16 gSpecs and usesRotating equipment & heat
Infrared surface-temperature sensor
CGUV-TEMP-DECL-001Non-contact infrared measurement of surfaces up to 1030 °C, including bearing housings, oven and kiln shells, dryer drums, compressor heads, and the lugs and breakers in a motor control center.−40 to 1030 °CNon-contactIP67Specs and usesPut the high-temperature probe, 500 °C to work.
The planner builds a gateway and sensor schedule around the problem you want to see. A Cognituv engineer confirms placement and coverage, then sends a quote.