Rotating equipment & heat · No. 07
Infrared surface-temperature sensor
CGUV-TEMP-DECL-001
Non-contact infrared measurement of surfaces up to 1030 °C, including bearing housings, oven and kiln shells, dryer drums, compressor heads, and the lugs and breakers in a motor control center.
- −40 to 1030 °C
- Non-contact
- IP67
- 8.5-yr battery
Specifications
At a glance.
| Measures | Surface temperature by infrared; ambient temperature |
|---|---|
| Range | −40 to 1030 °C target; adjustable emissivity |
| Mount | Bracket, aimed at the surface |
| Rating | IP67 |
| Power | Battery, about 8.5 years |
| current meter, 1000 A | |
| SKU | CGUV-TEMP-DECL-001 |
Confirm site suitability, calibration and current product specifications before ordering. The product data sheet governs.
Request the data sheet →Where it fits
Typical places for the infrared surface-temperature sensor.
Food & beverage
Compressor heads, dryer drums, extruder barrels, MCC lugs
General manufacturing
Dryer-can bearings, refiner housings, furnace shells, switchgear
Automotive
Oven shells, mold halves, hydraulic power units, shop MCCs
Warehousing & distribution
Sorter gearboxes, compressor heads, condenser fan motors, switchgear
Recommended for
More in rotating equipment & heat
All rotating equipment & heat →
Vibration & temperature monitor
CGUV-STRUC-AVAN-001Three-axis vibration and surface temperature with on-board condition analytics, mounted by magnet or stud on the bearing housing. Trending vibration and temperature shows bearing wear before it causes a failure.3-axis · ±16 gVelocity RMS · kurtosis · crestIP66Specs and usesRotating equipment & heat
Explosion-proof vibration monitor
CGUV-STRUC-AVAN-002The same three-axis vibration and temperature sensor, certified for hazardous locations. Use it in classified areas such as flour, feed, carbon-black and solvent handling, and use No. 5 elsewhere.ATEX / IECExZone 0 / 1 / 2±16 gSpecs and usesRotating equipment & heat
3-phase current meter, 500 A
CGUV-ENGY-MILE-003Three split-core clamps on one self-powered node report current, amp-hours and phase balance on a motor feeder, showing single-phasing, overload heating and motors left running when the line is idle.3 × 500 A clamps±1%Self-poweredSpecs and usesPut the infrared surface-temperature sensor to work.
The planner builds a gateway and sensor schedule around the problem you want to see. A Cognituv engineer confirms placement and coverage, then sends a quote.