Rotating equipment & heat · No. 06
Explosion-proof vibration monitor
CGUV-STRUC-AVAN-002
The same three-axis vibration and temperature sensor, certified for hazardous locations. Use it in classified areas such as flour, feed, carbon-black and solvent handling, and use No. 5 elsewhere.
- ATEX / IECEx
- Zone 0 / 1 / 2
- ±16 g
- 2-yr battery
Specifications
At a glance.
| Measures | Vibration (3-axis) and surface temperature |
|---|---|
| Certification | ATEX / IECEx, Zone 0 / 1 / 2 |
| Mount | Magnet or stud |
| Rating | IP65 |
| Power | Battery, about 2 years |
| SKU | CGUV-STRUC-AVAN-002 |
Confirm site suitability, calibration and current product specifications before ordering. The product data sheet governs.
Request the data sheet →Where it fits
Typical places for the explosion-proof vibration monitor.
Food & beverage
Hammer mills, pellet mills and bins inside the classified dust area; flour and sugar handling
General manufacturing
Carbon-black handling; converting dust areas
Automotive
Paint-mix rooms
Warehousing & distribution
Battery rooms where classified
Recommended for
More in rotating equipment & heat
All rotating equipment & heat →Rotating equipment & heat
Vibration & temperature monitor
CGUV-STRUC-AVAN-001Three-axis vibration and surface temperature with on-board condition analytics, mounted by magnet or stud on the bearing housing. Trending vibration and temperature shows bearing wear before it causes a failure.3-axis · ±16 gVelocity RMS · kurtosis · crestIP66Specs and usesRotating equipment & heat
Infrared surface-temperature sensor
CGUV-TEMP-DECL-001Non-contact infrared measurement of surfaces up to 1030 °C, including bearing housings, oven and kiln shells, dryer drums, compressor heads, and the lugs and breakers in a motor control center.−40 to 1030 °CNon-contactIP67Specs and usesRotating equipment & heat
3-phase current meter, 500 A
CGUV-ENGY-MILE-003Three split-core clamps on one self-powered node report current, amp-hours and phase balance on a motor feeder, showing single-phasing, overload heating and motors left running when the line is idle.3 × 500 A clamps±1%Self-poweredSpecs and usesPut the explosion-proof vibration monitor to work.
The planner builds a gateway and sensor schedule around the problem you want to see. A Cognituv engineer confirms placement and coverage, then sends a quote.