Rotating equipment & heat · No. 11
Waterproof PT100 probe, 200 °C
CGUV-TEMP-DRAG-014
Two-channel transmitter with waterproof braided-metal PT100 probes for compressor discharge, aftercooler outlet, CIP supply and steam condensate.
- −50 to 200 °C
- 2 channels
- Class A PT100
- Waterproof probe
Specifications
At a glance.
| Measures | Temperature on two probes |
|---|---|
| Range | −60 to 200 °C; ±0.5 °C (0–80 °C), Class A |
| Mount | Wall transmitter; 2 m probe leads |
| Rating | Transmitter −40 to 65 °C |
| Power | Battery |
| SKU | CGUV-TEMP-DRAG-014 |
Confirm site suitability, calibration and current product specifications before ordering. The product data sheet governs.
Request the data sheet →Where it fits
Typical places for the waterproof PT100 probe, 200 °C.
Food & beverage
Compressor discharge and aftercooler outlet; CIP supply temperature
General manufacturing
Compressor discharge; quench and process water
Automotive
Compressor discharge; wash and e-coat baths
Warehousing & distribution
Compressor discharge
Recommended for
More in rotating equipment & heat
All rotating equipment & heat →Rotating equipment & heat
Vibration & temperature monitor
CGUV-STRUC-AVAN-001Three-axis vibration and surface temperature with on-board condition analytics, mounted by magnet or stud on the bearing housing. Trending vibration and temperature shows bearing wear before it causes a failure.3-axis · ±16 gVelocity RMS · kurtosis · crestIP66Specs and usesRotating equipment & heat
Explosion-proof vibration monitor
CGUV-STRUC-AVAN-002The same three-axis vibration and temperature sensor, certified for hazardous locations. Use it in classified areas such as flour, feed, carbon-black and solvent handling, and use No. 5 elsewhere.ATEX / IECExZone 0 / 1 / 2±16 gSpecs and usesRotating equipment & heat
Infrared surface-temperature sensor
CGUV-TEMP-DECL-001Non-contact infrared measurement of surfaces up to 1030 °C, including bearing housings, oven and kiln shells, dryer drums, compressor heads, and the lugs and breakers in a motor control center.−40 to 1030 °CNon-contactIP67Specs and usesPut the waterproof PT100 probe, 200 °C to work.
The planner builds a gateway and sensor schedule around the problem you want to see. A Cognituv engineer confirms placement and coverage, then sends a quote.